Note the use of oil and gas separation filter an installation and maintenance when reaching economic considerations based on published individually identified when the final pressure, oil separator filter must be replaced, install, or replace the filter must be taken to ensure that the conditions are no errors. If the correct rotary seals (anti-static measures should be) emissions back to the oil management remaining oil return pipe must have sufficient length to reach the bottom of the end cap at the other. Install and replace the filter, the most important thing is to ensure that oils and oil separation tank dry and the side of the cleaning element, easy separation of the filter surface of the layer, to increase the oil carrying capacity, efficiency, impurities clogging the side of the filter was dried return line, causing gas with oil phenomenon. The destruction of the filter design pressure is 4bar, so after the compressor boost valve should be gradually opened up to the load calculation gas consumption needs, are strictly prohibited sudden emptying, resulting in rupture of the separation layer fine filter and filter flattening, and a large number carrying oil. Oil and gas separation filter design flow rate beyond the scope of the use of oil-carrying capacity is bound to increase. II. Ensure that some of the measures of economic working life of oil and gas separation filter to obtain a satisfactory working life is a basic prerequisite for the proper management of oilseeds, mainly limited working life just fine separation layer deposition of solid particles, the result is pressure increase. Typically timely replacement of oil filter and air filter and maintained at a certain time interval oil change, the oil can be locked into the circulation loop in the dirt, so that you can do to reduce dirt into the oil separator can be directly extended oil separator filter working life. Fuel selection is also very important and should only be used by the identification of a resistance to aging and water sensitivity of fuel, lack of NA oxidation of fuel in running after a relatively short period of time due to the formation of residues similar to jelly and clog filters, higher operating tests will accelerate the aging of the oil. Accordingly, attention must also be provided cold air and cooler medium. When all the oil used oil must be replaced in order to avoid changing the brand of the oil, residual oil and the new oil incompatible between the channeling of the adverse reactions and damage ten million